[求助]请问PADSLOGIC ECO 到PADSLAYOUT的问题

popcorn

请问各位大侠,我由PADSLOGIC ECO 到PADSLAYOUT时,

出现底下讯息,请问是什么意思？要找那个地方来更正呢？

敬请各位指教,谢谢﹗

............................................................................

** ECO In Report **

Wed May 13 20:34:19 2009

Input  File : C:\PADS Projects\eco2pcb.eco
Current Job : CC5.pcb

Line 119 , Section *SET_ATTRIBUTE*
"PART DEC."
* Name PART DEC. contains spaces between points.
* Attribute type "PART DEC." not found

Line 123 , Section *SET_ATTRIBUTE*
"PART DEC."
* Name PART DEC. contains spaces between points.
* Attribute type "PART DEC." not found

Line 127 , Section *SET_ATTRIBUTE*
"PART DEC."
* Name PART DEC. contains spaces between points.
* Attribute type "PART DEC." not found

..............................................................................

[此贴子已经被作者于2009-5-22 15:16:45编辑过]