|
SPB16.0已经出来啦，安装后用nolic破解，显示已经破解到GXL啦，CIS何Allegro都能用，只是在用FPM0.7生成封装时有的不能生成焊盘！显示的信息如下： Starting new drawing...
Starting new drawing...
Performing DRC...
No DRC errors detected.
No command active
W- (SPMHUT-48): Scaled value has been rounded off.
Loading axlcore.cxt
Creating package symbol 'c:/MYSYM/resc6332x70.psm'.
Starting Create symbol...
create_sym completed successfully, use Viewlog to review the log file.
create_sym completed successfully, use Viewlog to review the log file.
Symbol 'c:/MYSYM/resc6332x70.psm' created.
Writing database to disk.
'RESC6332X70.dra' saved to disk.
Writing database to disk.
'null.dra' saved to disk.
Loading cmds.cxt
Loading skillExt.cxt
W- (SPMHDB-63): Small extents ... sector size decreased to: 508,508
*WARNING* (axlCompileSymbol): Illegal symbol type - "shape"
W- (SPMHDB-62): Large extents ... sector size enlarged to: 1016,1016
W- (SPMHDB-63): Small extents ... sector size decreased to: 270,270
*WARNING* (axlCompileSymbol): Illegal symbol type - "shape"
W- (SPMHDB-62): Large extents ... sector size enlarged to: 540,540
W- (SPMHDB-62): Large extents ... sector size enlarged to: 1080,1080
E- (SPMHDB-273): Unable to load shape symbol SRX0_80Y3_40R0_10 (Check PSMPATH setting for this symbol).
E- (SPMHA1-161): Cannot open the design database file ... run standalone dbdoctor on the file.
W- (SPMHDB-63): Small extents ... sector size decreased to: 432,432
t
t
Command > 好像是不能创建 shape!
[此贴子已经被作者于2007-7-1 17:09:48编辑过] | 
[复制链接]
发表于 2007-6-26 14:56:00
楼主